USB In_Circuit Programmer for NXP LPC9xx series

Future Designs, Inc USB-ICP-LPC9XX

Tool    [What's This?]

$69.00

-Supports NXP P89LPC9xx family of microcontrollers
-USB port power so no external power supply required
-Supports USB 1.1 to 2.0
-Plugs directly into any standard USB Port - great for laptops
-Works with NXP free Flash Magic software that can be downloaded from the web
-USB-ICP supports Target Device Voltage range of 3.0 - 3.3V

USB-ICP supports the new In-Circuit Programming or ICP mode on NXP microcontroller families such as the LPC9xx. In-Circuit Programming uses a two-wire serial interface to program and erase ICP enabled microcontroller devices without removing them from the system. The ICP function uses only five pins: VCC, GND, PCL, PDA, and RSTn. A small connector is all that is needed to interface your application to the USB-ICP programmer

USB-ICP Kit Includes:
-USB-ICP dongle
-18” cable allowing direct connection to the user's application
-ISP design guide for the user’s target board

NXP LPC9xx

See Supported Device List in Resource Center at the right of this page