USB In_Circuit Programmer for NXP LPC2xxx series

Future Designs, Inc USB-ICP-LPC2K

Tool    [What's This?]

$79.00

-Supports ALL NXP ARM 7 LPC2K family of microcontrollers that utilize ISP Programming
-Now supports ARM Cortex-M3 LPC17xx microcontrollers
-USB port power so no external power supply required
-Supports USB 1.1 to 2.0
-Plugs directly into any standard USB Port - great for laptops
-Works with NXP free Flash Magic software that can be downloaded from the web
-USB-ICP supports Target Device Voltage range of 3.0 - 3.3V

USB-ICP-LPC2K supports In-System Programming (ISP) on NXP ARM7 LPC2xxx microcontroller family. In-System Programming uses a two-wire serial interface to program and erase ISP enabled microcontroller devices without removing them from the system. The ISP function uses only six pins: VCC, GND, RXD, TXD, P0.14 and RESETn. A small connector is all that is needed to interface your ISP application to the USB-ICP programmer.

USB-ICP Kit Includes:
-USB-ICP dongle
-18” cable allowing direct connection to the user's application
-ISP design guide for the user’s target board

NXP LPC17xx, NXP LPC2xxx

See Supported Device List in Resource Center at the right of this page