USB In_Circuit Programmer for NXP 80C51 series

Future Designs, Inc USB-ICP-80C51ISP

Tool    [What's This?]

$69.00

-Supports NXP P89C51 family of microcontrollers
-USB port power so no external power supply required
-Supports USB 1.1 to 2.0
-Plugs directly into any standard USB Port - great for laptops
-Works with NXP free Flash Magic software that can be downloaded from the web
-USB-ICP supports Target Device Voltage range of 3.0 - 5.0V only

USB-ICP supports In-System Programming or ISP mode on NXP 80C51 based microcontroller families. In-System Programming uses a two-wire serial interface to program and erase ISP enabled microcontroller devices without removing them from the system. The ISP function uses only six pins: VCC, GND, RXD, TXD, PSEN- and RESET. A small connector is all that is needed to interface your application to the USB-ICP programmer.

USB-ICP Kit Includes:
-USB-ICP dongle
-18” cable allowing direct connection to the user's application
-ISP design guide for the user’s target board

8051

See Supported Device List in Resource Center at the right of this page